====== Summit Command ======
====== port情報確認 ======
# sh port 1 info detail
Port 1:
Type: UTP
Diagnostic: passed
Aggregate B/W: Configured 100 %
Random Early Drop: Disabled
Admin state: Enabled, with auto-duplex auto-speed sensing
Link state: Active. Full-duplex 100 Mbps.
Link counter: Up 3 time(s), Down 2 times(s)
Link Filter counter: Up 3 time(s), Down 2 times(s)
VLAN cfg:
n192.168.50 [Internal Tag=0050,Mac-Limit:Cfg=No-limit,LRN=1,BlkHole=0]
STP cfg:
Trunking: Load sharing is not enabled
Protocol: VLAN=n192.168.50 Vpri=0 Protocol=ANY [EtherType:ffff]
EDP: enabled
DLCS: disabled
lbdetect: disabled
Learning: enabled
Flooding: enabled
Jumbo: Disabled
BG QoS monitor: disabled
Ingress Rate Shaping:
QoS profile: None configured
・
・
・
====== リンクスピード変更 ======
===== 書式 =====
configure ports [ | all | mgmt] auto off {speed [10 | 100 |1000]} duplex [half | full]
configure ports 1 auto off duplex full speed 10
configure ports 1 auto off duplex full speed 100
===== 元に戻す =====
configure port 1 auto on